Complete with a lifelike prosthetic in the skin tone of your choice, our Xtreme Solution is designed to be undetectable and toxin-free. Includes: adjustable elastic belt with pouch, 2 powdered urine vials, 4 Clear Choice heat pads, syringe to fill the product, easy to read temperature strip and detailed instructions.
PLEASE NOTE: Cut off times for this product are USPS 1:20pm and FedEx 3:10pm EST
Using the supplied syringe, measure out 100cc/ml of distilled or bottled water into a clean cup.
Take ONE refill vial and empty the entire contents into the cup of measured water.
Mix or swirl the cup until completely dissolved. Sometimes the vial will become clumpy this is OK it will only take longer to dissolve, and will NOT affect it at all.
Unscrew and remove the bag from the belt. The fill port is located between the operation valve and the prosthetic. Make sure the valve is open at this time. The valve fingers will point up and down when open.
Using the syringe suck up the mixed solution and inject it into the bag. Make sure to close the valve after injecting fluid so it does not leak back out. Valve fingers will be pointing left to right.
Remove one adhesive backing strip from the supplied heat pad and apply it just below the Velcro on the bag.
This will make it easy to remove after use.
You only need ONE heat pad, DO NOT apply more. The heat pad needs to be stuck to the bag on the opposite side of the temperature strip.
Reinstall the bag assembly to the belt. The heat pad should be sandwiched between the bag and the belt. Making sure the heat pad is stuck directly to the vinyl bag, NOT the belt. Do NOT over tighten fill port connection, this will cause damage or crack the plastic and cause a leak.
Put on the belt with the thermometer temperature strip coming in contact with your body. You must wear the belt with the heat pad attached for up to one hour for it to reach the proper range of 94-100 degrees.
The heating pad in combination with your body heat will maintain the proper temperature for up to 8 hours.
This product will NOT overheat when using the supplied heating pads, they are designed to not reach over 102 degrees.
Monitor temperature. For the most realistic effect; allow the temperature to reach 94-100 degrees before use. DO NOT check the temperature every couple of minutes, pulling the bag away from the primary heat source (Your body) will make it challenging to reach 94-100 degrees.
After use clean and flush the bag several times, and store with the valve open.
